1.TROUBLESHOOTING FOR THE HARDWARE
52 Clearing a Paper Misfeed
3
Holding the green knob, move the guide to the right.
4
Raise the lever and open the upper receiving tray of the finisher.
5
Open the cover of the Hole Punch Unit when it is installed.
6
Turn the knob shown in the following figures to send the paper, and then remove the misfed
paper.
When the Hole Punch Unit is installed, open the front cover of the finisher and turn the 2 knobs at the same time.
Be sure to turn the knob to the direction indicated by the arrow to remove the misfed paper. If you pull out the
paper forcibly without turning the knob, this may tear the paper.
Some misfed paper may get inside of the Saddle Stitch unit depending on the location where the misfeeding
occurs. In this case, follow step 7.
When the Hole Punch Unit is not installed
When the Hole Punch Unit is installed
To Next Page
Loading...
