Toshiba e-STUDIO4518A - General settings

17
TABLE 2- Correspondence Table when checking Options
No.
Inspection
Item
Option connect
status
Inspection
result
Correspondence
9
PCIE ASIC1
DSDF
unit connected.
OK ？
(If the DSDF
unit is
connected
properly, result is
"OK")
Step 1. Check the installation
status of the DSDF I/F board.
Step 2. Replace the DSDF IF
board.
Step 3. Replace the SYS
board.
11
NETWORK
LAN connector
connected
OK? [LINK
DOWN]
It is displayed as
below)
"OK[Connect
speed *]"
* Connect
speed : 10, 100,
1000Mb/s
Step 1. Check the installation
status of the LAN connector.
Step 2. Check and replace LAN
cable if necessary.
Step 3. Replace the SYS
board.
12
SATA I/F &
SMART
NG [LINK
DOWN]
NG [SPD]
----
If necessary, perform
HDD format and reinstall
the software.
13
USB Host
OK?
Number of USB
device
connections
(NG will not be displayed)
14
USB FAX
Two Fax boards
connected
OK?
[Fax1 detected]
Step 1. Check if connectors
(CN102,CN104) are connected.
Step 2. Check and replace the
connect harness if necessary.
Step 3. Replace the Fax board.
Step 4. Replace the SYS
board.
（ Continued on next page ）