62 Replacing the Waste Toner Box
0.Replacing the Waste Toner Box
When the waste toner box becomes full, the symbol for replacement of the waste toner box blinks and the message
“Dispose of used toner” appears. Replace the waste toner box following the procedure below.
Never attempt to incinerate waste toner boxes.
Dispose of used toner cartridges and waste toner boxes in accordance with local regulations.
1
Separate the Finisher from the equipment.
1. Open the front cover of the finisher when the Hole Punch Unit is not installed. Open the Hole Punch Unit cover
when the Hole Punch Unit is installed.
2. Pull the lever to unlock the finisher.
3. Placing your hands on the positions shown in the figure, move the finisher slowly until it stops, and then open
the front cover of the finisher.
When the Hole Punch Unit is not installed When the Hole Punch Unit is installed
When the Hole Punch Unit is not installed When the Hole Punch Unit is installed
When the Hole Punch Unit is not installed When the Hole Punch Unit is installed
To Next Page
Loading...
Need help?
General
