To Next PageTo Next PageWhat to do if I see residue or metal dust in my Toshiba Heat Pump?
If you observe discolored oil, a large quantity of residue, shiny metal dust, or other wear residue or mixture of foreign matter, the existing pipes should not be reused as they are.
What to do if there is a heavy scratch or dent on my Toshiba HWT-1101H8RW-E pipe?
If there is a heavy scratch or dent on the pipe, be sure to use new pipes for the refrigerant piping works.
What to do if existing pipe thickness is thinner than specified for my Toshiba HWT-1101H8RW-E Heat Pump?
If the existing pipe thickness is thinner than the specified 'Pipe diameter and thickness,' be sure to use new pipes for the refrigerant piping works.
General| Model | HWT-1101H8RW-E |
|---|---|
| Category | Heat Pump |
| Heating Capacity (kW) | 3.2 |
| SEER | 6.1 |
| SCOP | 4.0 |
| Refrigerant | R32 |
| Power Supply | 220-240V, 50Hz |
| Energy Efficiency Ratio (EER) | 3.2 |
Crucial safety precautions for handling R32 refrigerant during installation and servicing.
Guidelines for installing refrigerant piping, including materials and processing.
Procedure for recharging the system with the specified amount of new refrigerant.
Guidelines and cautions for charging additional refrigerant to ensure reliability.
Comprehensive safety precautions for working with R32 refrigerant.
Initial checks to perform before diagnosing failures.
Detailed flow charts for diagnosing failures based on check codes.
