168
13. Display Function of Set Temperature and Other Settings
• The sensor sensing temperature is displayed on the remote controller.
• This function allows you to make sure whether the sensor is installed properly.
▼Sensor temperature display calling
<Procedure>
1 Press the [ ] button and the [ ] button at same time for 4
seconds or longer on the top screen to display the “FIELD SETTING
MENU”.
2 Press the [ ] / [ ] button to select “Service monitor” on the
FIELD SETTING MENU screen, then press the [
] button.
3 Press the [ ] button to select the unit,
then press the [
] button to display
the status.
Service monitor
FIELD SETTING MENU(2/2)
Hydro Unit DN
Remote controller DN
Reset power consumption data
Sensor information
SET
Service monitor
1 - 1
1 - 4
1 - 2
1 - 3
1 - 5
1 - 6
1 - 7
1 - 8
SET
UNIT
Service monitor
Code Data
RETURN
To Next Page
Loading...
