No. skrameR
Fan guard
1. Detachment
1) Following to work of Detachment of
NOTE
Do the work on a cardboard or a cloth to prevent the
product from being scratched.
2. Attachment
NOTE
Ensure that all the claws are fixed in their specified
position.
[Reference]
Sensor
mount
positions
1) TD sensor: discharge pipe
2) TL sensor: heat exchanger upside
3) TS sensor: 4-way valve - between accumulator
4) TE sensor: lowest capillary joint
5) TO sensor: Heat exchange surface
1) TD sensor
2) TL sensor
2)
2) TL sensorTL sensor2) TL sensor
SCREWS
SCREWS
5) TO sensor
5) TO sensor 5) TO sensor
1) TD sensor
1) TD sensor 1) TD sensor
4) TE sensor
3) TS sensor
3) TS sensor
3) TS sensor
4) TE sensor4) TE sensor
3) TS sensor
4) TE sensor
Hooking craws
Hooking craws
2) Remove the 4 screws that secure the fan guard.
(Φ4× 10, hexagonal screws)
3) Remove the Air outlet cabinet and place the fan guard
side facing down.
4) Remove the craws (4 places) of the fan guard.
1) Hook the hooking claws from the front side and press
the craws (4 places) by hand to fix them in place.
2) Fix the fan guard to the air outlet cabinet with 4
screws. (Φ４× 10, hexagonal screws)
Work procedure
Exchange
parts name
To Next Page
Loading...
