Toshiba IK-DP30A User Manual

INSTRUCTION MANUAL
DOME CAMERA
IK-DP30A
TABLE OF CONTENTS
IMPORTANT SAFEGUARDS ................................................ 2
1. Features and description .............................................. 4
2. Cautions ........................................................................ 4
3. Components ................................................................. 4
4. Part names and Locations ............................................ 5
5. Connections .................................................................. 6
6. Operation ...................................................................... 7
7. Menu Directory ............................................................. 29
8. Switch Setting ............................................................... 31
9. Installation..................................................................... 34
10. Specifications................................................................ 37
Please read this manual thoroughly before use, and keep it handy
for future reference.
Record in space provided below the Model No. and
the Serial Number as found on the label on the
bottom of the camera.
Model. No. IK-DP30A Serial No.
Retain this information for future reference.
ZEIM-4000008G A.1

Toshiba IK-DP30A Specifications

General

Wide Dynamic Range	Yes
Lens Mount	CS Mount
Video Output	1.0 V [p-p], 75 ohms, unbalanced
Power Supply	DC 12V ±10%
Day/Night	Yes
Operating Temperature	-10°C ~ +50°C
S/N Ratio	52 dB

Summary

IMPORTANT SAFEGUARDS

General Safety and Operational Guidelines

Covers reading instructions, retaining manual, heeding warnings, and following procedures for safe operation.

5. Connections

Basic Wiring and Controller Connection

6. Operation

Menu Navigation and Access

Pan/Tilt and Scan Functions

6.7 CAMERA SETUP

Focus, White Balance, and AE Control

Zoom, Sharpness, Line Lock, and Privacy Zone

6.8 PAN/TILT SETUP

Auto Flip, Proportional P/T, and Scan Limits

7. Menu Directory

7.1 MENU LIST AND SETTINGS

8. Switch Setting

DIP Switch Configuration

Explains the setup of DIP switches for camera address, protocol, and bit rate.

Camera Address and SW1 Settings

Details how to set the camera address using SW1 DIP switches.

Protocol, Bit Rate, and Termination

Covers setting protocol, bit rate using SW2, and the termination switch.

9. Installation

Ceiling Mount Housing Preparation

Instructions for preparing the ceiling mount housing, including hole cutting and cover removal.

Housing Installation Steps

Steps for installing the housing into the ceiling, securing support arms, and passing cables.

Dome Base and Drive Installation

Guides on attaching video/communication cables and installing the dome base and drive.