Toshiba M-672 - Page 24

2-8-22. Assembly of Gear Master
2-8-24. Lever Slide Pinch Removal
1) When reinstalling, be sure to align the arrow mark of
gear master
a with gear home of gear worm wheel a
(Refer to timing point)
@ GEAR WORM WHEEL
UNIT LOADING
00
Fig. 48 Assembly of Gear Master
2-8-23.
Unit Loading Removal
1) Remove twoQ) screws 0.
2) Lift the unit loading @ in the direction of arrow.
p--?
Q TWO SCREWS
Fig. 49 Unit Loading Removal
LOADING
1) Remove the washer slit a.
2) Lift the lever slide pinch a,
@ WASHER-SLIT
@I LEVER SLIDER PINCH
/
<-,
Fig. 50 Lever Slide Pinch Removal
2-8-25.
Assembly of Lever Slide Pinch
1) Pull the slide pinch @to the end in the direction
of arrow.
2) Insert the slide pinch (j) into the hole of lever slide
pinch (p. (Refer to ‘A’ part)
@ SLIDER-PINCH
LEVER SLIDER PINCH
SLIDER PINCH BOSS
Fig. 51 Assembly of Lever Slide Pinch
2-23