Toshiba M-672 - Page 25

2-8-28. Slide Main Removal
1) Remove the washer slit a.
2) Release three(3) tabs QI, @, @ in the direction of arrow.
3) Lift the slide main 6).
@ WASHER SLIT
2-8-27. Assembly of Slide Main
1) Install the shaft of gear loading ‘R’ ass’y into the left of
the main slide hole and secure with the washer slit
a.
(Refer to ‘A’)
2) Insert the lever tension control
Q) and the lever idler
change @ into the slide main hole. (Refer to ‘B’)
3) After confirming the above items 1), 2) install the slide
main and secure with tabs
(a, b, c).
Fig. 52 Slide Main Removal
CBL
NOTE: Be sure to assemble the side main when the
gear loading i/r assy is inunloading posision.
a
EVER
@ GEAR-LOADING’R’ASSEMBLY
G "L" ASSEMBLY
0 LEVER-IDLER CHANGE ’
I
0 LEVER-TENSION CONTB~~
7
@ LEVER-REC S/W
NOTE : Seven parts should be installed into the
side main hole.
Fig. 53 Assembly of Slide Main (Bottom view)
CAM
LEVER REVIEW
‘r-------’ \ I I
NOTE: Six parts should be installed into the side
main hold.
A
Fig. 54 Assembly of side Main(Top view)
2-24