Toshiba M-672 - Page 26

2-8-28. Lever Shift Ass’y Removal
2-8-30. Gear Loading ‘I”, “R” Ass’y Removal
1) Hang the spring lever shift (D to the claw of the lever
shift @. (Refer to detail drawings ‘A’, ‘B’)
2) Release the tab @ in the direction of arrow.
3) Lift the lever shift @.
@ SPRING LEVER SHIFT
\
@ LEVER SHIFT
I ,
@I LEVER SHIFT
F
@ SPRING LEVER SHIFT
*
<DETAIL “A”>
Fig. 55 Lever Shift Ass’y Remova
<DETAIL ‘B’>
2-8-29. Lever Idler Change Removal
1) Release the tab @ in the direction of arrow.
(Refer to detail drawing)
2) Lift the lever idler change
7 @ LEVER IDLER CHANGE
Fig. 56 Lever Idler Change Remo
1) Remove the gear loading ‘R’ ass’y @ from the slide
guide roller ‘T (3, by pushing the spring loading ‘R’ a
in the direction of arrow. (Refer to detail drawing ‘A’)
2) Remove the gear loading ‘L’ ass’y Q from the slide
guide roller ‘s’ @ by pushing the spring loading ‘L’ @
in the direction of arrow. (Refer to detail drawing ‘B’)
3) Lift the gear loading ‘R’ ass’y a.
4) Lift the gear loading ‘L’ ass’y @ by pushing the tab Q of
the gear loading ‘L’ ass’y a. (Refer to detail drawing ‘C’)
f---- @ GEAR LOADING ‘R’ AS’Y
@ GEAR LOADING ‘L’ ASS
ASS’Y
44’
@ SPRING LOADING (R)
11 @ SPRlNG LoADlNG (L)
<DETAIL “A”>
<DETAIL 9%
Fig. 57 Gear Loading ‘L’, ‘R’ Ass’y Removal
2-8-31. Gear Loading ‘I”, “R” Ass’y
1) When reinstalling, be sure to align two arrows as shown
in Fig. 58. (Refer to timing point)
ALIGN TWO ARROWS
GEAR LOADING
“R’ASS’Y \
GEAR LOADING
Fig. 58 Assembly of Gear Loading ‘L’, ‘R’ Ass’y
2-25