2-8-36. Full Erase Head Removal
1)
Remove one0
)
screw
Q).
2)
Lift the magnet WE head 8).
f---
@
ONE SCREW
@
MAGNET F/E HEAD
Fig. 63 Full Erase Head Removal
2-8-37. ACE Head Removal & Reassembly
1)
Release the tab @ holding holder ACE toward arrows.
(Refer to detail drawing ‘A’)
2)
Remove
one(l)
screw
QI.
3) Lift the magnet ACE head ass’y
@.
Assembly
:
When reinstalling, be sure to align the three
teeth of X-Position adju$tment gear with the
two slot of ACE head base.
NOTE
:
When adjusting the X-position adjustment gear
using
1~)
driver, do not adjust by force.
r-------
2-8-38.
Slide Guide Roller “s”,
“T”
Ass’y
Removal
1)
Remove the cylinder ass’y from the main base.
(Refer to Fig. 19,
20)
2)
Remove the slide
‘s’,
T
from the gear loading ‘L’,
‘R
ass’y. (Refer to Fig.
58)
3)
Move the guide roller ‘S’,
‘T
ass’y to slot and then lift it
to remove. (Refer to arrow)
Fig. 65 Slide Guide Roller
‘s’,
‘T
Ass’y Removal
i
--
I
---%J
r-n/
-r-z
,#
HOLDER ACE
I
“ul
1
<DETAIL
‘A=>
7
Fig. 64 ACE Head Ass’y Removal & Reassembly
2-27
To Next Page
Loading...
