2-8-39. Slide Guide Roller “S”,
“T”
Ass’y
(When all parts except the cylinder
assembly are removed.)
1) Push four(4) Lever Locks
a
of the housing ass’y
Simultaneously. (Refer to Fig. 66)
2) Push the holder cassette
ass)
@toward arrow ‘B’ while
turning the gear master
Q
toward arrow ‘A’.
(Refer to Fig.
66)
3) Load the gear loading L, R ass’y
@.
a
to the middle
position of guide rail by turning the gear master
Q
toward arrow ‘A’. (Refer to Fig. 66, 67)
4)
Install the slide guide roller S, T
@,
QJ
into rail slot and
then move it to the position of gear loading L,
R
ass’y
0,
a.
(Refer to Fig.
67)
5)
Turn the gear master @ toward arrow ‘A’. (Eject mode)
k2_
0
HOMIER
CASSETTE
ASSEMBLY
Fig. 66 How to operate the Housing Ass’y
@
SLIDER
G/R
ASSY (T)
Fig. 67 Assembly of Slide Guide Roller
‘s’,
‘r
Ass’y
2-28
To Next Page
Loading...
