To Next PageTo Next PageWhy won't the compressor start on my Toshiba Air Conditioner?
If the compressor of your Toshiba Air Conditioner won't start, consider these possibilities: * It might be within the 3-minute delay period after a compressor shutdown. * The air conditioner might have thermo OFF. * It could be operating in fan mode or set on a timer. * The system might be undergoing initial communication.
Why won't the indoor fan stop on my Toshiba MMD-AP0364BH-E Air Conditioner?
If the indoor fan of your Toshiba Air Conditioner won't stop, it might be performing the elimination of residual heat as part of the air conditioner shutdown process after heating operation.
Why won't the indoor fan start on my Toshiba MMD-AP0364BH-E Air Conditioner?
If the indoor fan of your Toshiba Air Conditioner won't start, it could be due to cold air discharge prevention control, which is a part of the heating process.
Why does the outdoor fan on my Toshiba MMD-AP0364BH-E not start or change speed?
If the outdoor fan of your Toshiba Air Conditioner doesn't start or changes speed unexpectedly, it might be due to cooling operation under low outside temperature conditions or during a defrosting operation.
General| Cooling Capacity (kW) | 3.6 |
|---|---|
| Heating Capacity (kW) | 4.0 |
| Power Source | 220-240V, 50Hz |
| Refrigerant | R410A |
| Energy Efficiency Ratio (EER) | 3.21 |
| Coefficient of Performance (COP) | 3.61 |
| Type | Split System Air Conditioner |
Lists models for 4-way cassette indoor units.
Lists models for 1-way cassette indoor units.
Details requirements and knowledge for a qualified installer.
Details requirements and knowledge for a qualified service person.
Explains danger, warning, and caution indications used in the manual.
Lists required protective gear for different work types.
Details procedures for turning off the circuit breaker before maintenance.
Explains risks of electric shock and waiting periods after power off.
Details safe practices for handling refrigerants like R410A.
Provides guidelines for safe work at heights, including ladder use and signage.
Provides details about the manufacturer and authorized representative.
Presents sound power levels and weights for different indoor unit models.
Shows the wiring diagram for the Compact 4-way cassette type indoor unit.
Details parts and their ratings for the Compact 4-way Cassette type.
Explains the function of key parts in the indoor unit's refrigerant cycle.
Details control specifications for power supply reset, operation selection, and capacity control.
Provides block diagrams for indoor controller configurations.
Identifies various components and connectors on the MCC-1402 P.C. board.
Provides the steps to operate and clear the test operation function.
Step-by-step procedure for setting DN codes using the remote controller.
Details DN codes for Type and Indoor unit capacity settings.
Details wiring and control items for the TCB-IFCB4E2 interface.
Describes the initial steps for address setting, including button presses and LCD display.
Details how to view the system and indoor unit address.
Details the procedure for changing the address of an individual indoor unit.
Guides on clearing errors for both outdoor and indoor units.
Outlines the general troubleshooting steps and common behavioral problems with their possible causes.
Lists check codes detected by indoor units and their typical fault sites.
Explains how to check current faults and error history using the main remote controller.
Lists check codes and their display locations on controllers and outdoor units.
Details the meaning of light block indicators for check codes and their causes.
Covers check codes for indoor and outdoor unit sensor errors.
Details the E31 check code for IPDU communication errors and troubleshooting steps.
Lists check codes for indoor and outdoor sensor errors.
Details the steps for replacing indoor P.C. boards and noting important points.
Describes the procedure when the unit can be powered on and data read via remote controller.
Details procedures when the unit cannot be powered on or data read via remote controller.
Guides on reading setting data from EEPROM using the remote controller.
Provides instructions for removing and installing the air intake grille.
Provides instructions for removing and installing the air intake grille.
Provides instructions for removing and installing the air filter.
Details the procedure for removing and attaching the plate inlets.
Provides instructions for removing the electrical control box.
Provides step-by-step instructions for replacing the fan motor.
Provides instructions for removing and installing the intake grille.
Provides step-by-step instructions for removing the electrical control assembly.
Shows an exploded view of the 1-way cassette (YH) type components.
Details the parts list for the specified 1-way cassette (YH) models.
Shows an exploded view of the 1-way cassette (SH) type components.
Details the parts list for the specified 1-way cassette (SH) models.
Shows an exploded view of components for the Compact 4-way Cassette type.
Shows an exploded view of components for the Slim Duct type.
Shows an exploded view of components for the Concealed Duct Standard Type.
Shows an exploded view of components for the Concealed Duct High Static Pressure Type.
Shows an exploded view of components for the Ceiling type.
Shows an exploded view of components for the Floor Standing type.
Shows an exploded view of components for the Floor Standing Concealed Type.
Shows an exploded view of components for the Floor Standing Cabinet Type.
