Toshiba MMY-MAP1006HT8P-E - User Manual

25 pages

Save Page as PDF

To Next Page

For commercial use

AIR CONDITIONER (MULTI TYPE)

Owner’s Manual

Outdoor Unit

Model name:

MMY-MAP0806HT8P-E

MMY-MAP1006HT8P-E

MMY-MAP1206HT8P-E

MMY-MAP1406HT8P-E

MMY-MAP1606HT8P-E

MMY-MAP1806HT8P-E

MMY-MAP2006HT8P-E

MMY-MAP2206HT8P-E

MMY-MAP0806HT8JP-E

MMY-MAP1006HT8JP-E

MMY-MAP1206HT8JP-E

MMY-MAP1406HT8JP-E

MMY-MAP1606HT8JP-E

MMY-MAP1806HT8JP-E

MMY-MAP2006HT8JP-E

MMY-MAP2206HT8JP-E

MMY-MAP0806T8P-E

MMY-MAP1006T8P-E

MMY-MAP1206T8P-E

MMY-MAP1406T8P-E

MMY-MAP1606T8P-E

MMY-MAP1806T8P-E

MMY-MAP2006T8P-E

MMY-MAP2206T8P-E

MMY-MAP0806T8JP-E

MMY-MAP1006T8JP-E

MMY-MAP1206T8JP-E

MMY-MAP1406T8JP-E

MMY-MAP1606T8JP-E

MMY-MAP1806T8JP-E

MMY-MAP2006T8JP-E

MMY-MAP2206T8JP-E

English

Main Page

Other manuals for Toshiba MMY-MAP1006HT8P-E

Installation Manual88 pages

Questions and Answers

K
Kimberly JacksonAug 6, 2025
Why is my Toshiba MMY-MAP1006HT8P-E Air Conditioner not cooling or warming enough?
- W
  William BlankenshipAug 6, 2025
  Your Toshiba Air Conditioner might not be cooling or heating the air sufficiently due to several reasons. Check if the air intake or air discharge of the outdoor unit is obstructed. Ensure that all doors and windows are closed. A clogged air filter can also reduce efficiency, so clean it if it's dusty. Make sure the discharge louver of the indoor unit is set to the appropriate position. Also, verify that the air selection isn't set to “LOW” or “MED,” and the operation mode isn't set to “FAN”. Confirm that the set temperature is appropriate and that COOL and HEAT are not selected simultaneously. Finally, check if the outdoor temperature is within the operational temperature range.
B
Brittany GuerreroAug 19, 2025
What to do if my Toshiba Air Conditioner does not operate?
- P
  patricia15Aug 20, 2025
  If your Toshiba Air Conditioner is not operating, first check for a power failure. Ensure that the power switch is turned on and that the power fuse or breaker hasn't blown. Also, check if the protective device has operated (the operation lamp goes on). Verify that the timer is not set to “ON” (the operation lamp goes on). Make sure that COOL and HEAT are not selected simultaneously (“ ” indication is lit on the display of the remote controller). Finally, confirm that the outdoor temperature is within the operation temperature range.