MPEG2 sound
You can enjoy motion picture and live concert DVD video discs with dynamic realistic sound by connecting an
amplifier equipped with an MPEG2 audio decoder or MPEG2 audio processor.
A"'mplifierequipped with an'_
MPEG2 audio decoder /
To COAXIAL _
type digital ! To COAXIAL DIGITAL
audio input / AUDIO OUT y
| 75 f! coaxial cable (not supplied)
g*
Use DVD video
discs encoded via
the Dolby Digital
recording system.
o
o
I'B
2-.
o
=1
®
2 channel digital stereo
You can enjoy the dynamic sound of 2 channel digital stereo by connecting an amplifier equipped with a digital
audio input and speaker system (right and left front speakers).
_ Amplifier equipped with al ab !!_X_ [_ Lj_I
v I L__° Digital audio input J
I ToCOAX,AL
I type digital I[ To
I audio input |
L 75 f) coaxial c t
®
Notes:
DO NOT connect the COAXIAL DIGITAL AUDIO OUT jack of the unit to the AC-3 RF input of a Dolby Digital Receiver. This
input on your AN Receiver is reserved for Laserdisc use only and is incompatible with the COAXIAL DIGITAL AUDIO OUT
jack of the unit.
Connect the COAXIAL DIGITAL AUDIO OUT jack of the unit to the "COAXIAl" input of a Receiver or Processor.
* Refer to the owner's manual of the connected equipment as well.
* When you connect the unit to other equipment, be sure to turn off the power and unplug all of the equipment from the wall
outlet before making any connections.
* The output sound of the unit has a wide dynamic range. Be sure to adjust the receiver's volume to a moderate listening level.
Otherwise, the speakers may be damaged by a sudden high volume sound.
Turn off the amplifier before you connect or disconnect the unit's power cord. If you leave the amplifier's power on, the
speakers may be damaged.
5Y40101A indb 17
17
2'2 _006 : 8 I5AM ]
To Next Page
Loading...
