User’s Manual 8-10
Troubleshooting
USB floppy diskette drive
For further information, please refer to Chapter 3, Hardware, Utilities and
Options.
Check the type of CD/DVD you are using. The
drive supports:
DVD-ROM: DVD-ROM, DVD-Video
CD-ROM: CD-DA, CD-Text, Photo CD
(single/multi-session),
CD-ROM Mode 1, Mode 2,
CD-ROM XA Mode 2
(Form1, Form2), Enhanced
CD (CD-EXTRA),
Addressing Method 2
■ DVD Super Multi drive
Recordable DVD: DVD-R, DVD+R, DVD-RW,
DVD+RW, DVD-RAM
■ DVD Super Multi drive Double Layer
Recordable DVD: DVD-R/-R DL, DVD+R/
+R DL, DVD-RW,
DVD+RW, DVD-RAM
Check the region code on the DVD. It must
match that on the DVD Super Multi drive. Region
codes are listed in the Optical disc drives section
in Chapter 2, The Grand Tour.
Problem Procedure
Problem
Procedure
Drive does not operate Check the connection between the computer and
the drive to ensure that it is properly attached.
Some programs run
correctly but others do
not
The computer's software or hardware
configuration may be causing a problem - ensure
that these configurations match your
requirements (refer to any relevant
documentation, for example that supplied with
any software in use, for further information).
You cannot access the
external floppy diskette
drive
Try another floppy diskette in the drive - if you
are able to access this disk then it indicates the
original disk and not the drive is probably causing
the problem.
If you are still unable to resolve the problem,
contact your reseller, dealer or service provider.
To Next Page
Loading...
