Toshiba RAS-07PKVP-ND User Manual (English)

Other manuals for Toshiba RAS-07PKVP-ND

Service Manual114 pages

Installation Manual26 pages

Questions and Answers:

A
Amy GonzalezAug 7, 2025
What to do if my Toshiba RAS-07PKVP-ND Air Conditioner is not turning on?
- S
  Sheri WilliamsAug 7, 2025
  If your Toshiba Air Conditioner is inoperative, there are several possible reasons. First, ensure that the main power switch is turned on. Also, check if the circuit breaker has been activated, cutting off the power supply, and reset it if necessary. Examine the main power fuse and replace it if it has blown. Verify that there is an electric current. Replace the batteries in the remote controller. If the ON timer is set, disable it. Finally, remember that as a protective measure, the air conditioner may not operate for 3 minutes after restarting or turning on the main power; wait for 3 minutes and try again.
J
Jessica BlevinsAug 17, 2025
Why is my Toshiba RAS-07PKVP-ND Air Conditioner not cooling properly?
- B
  Benjamin YoderAug 18, 2025
  If your Toshiba Air Conditioner isn't cooling effectively, several factors could be responsible. Check that the air inlet or outlet of the outdoor unit isn't blocked. Ensure all doors and windows are closed. A clogged air filter can also reduce performance, so clean it. Make sure the louver is correctly positioned. Check that the fan speed isn't set too low, and adjust it as needed. The air conditioner might be in DRY or SLEEP mode, so switch to a more suitable setting. If you are in cooling operation, the temperature setting might be too high, so lower it. Finally, ensure that the air conditioner is being used within its specified operating conditions. If none of these steps work, remove the cause of the problem, and after about 30 seconds, turn on the circuit breaker again.
D
Dylan BushAug 27, 2025
What to do if my Toshiba RAS-07PKVP-ND is not heating properly?
- A
  adamleeAug 28, 2025
  If your Toshiba Air Conditioner isn't heating effectively, several factors could be responsible. Check that the air inlet or outlet of the outdoor unit isn't blocked. Ensure all doors and windows are closed. A clogged air filter can also reduce performance, so clean it. Make sure the louver is correctly positioned. Check that the fan speed isn't set too low, and adjust it as needed. The air conditioner might be in DRY or SLEEP mode, so switch to a more suitable setting. If you are in heating operation, the temperature setting might be too low, so increase it. Finally, ensure that the air conditioner is being used within its specified operating conditions. If none of these steps work, remove the cause of the problem, and after about 30 seconds, turn on the circuit breaker again.

Toshiba RAS-07PKVP-ND Specifications

General

Technology	Inverter
Heating Capacity	2.5 kW
Power Supply	220-240V, 50Hz
Indoor Unit Weight	9 kg
Type	Split
Cooling Capacity (BTU)	7000 BTU/h
Outdoor Unit Noise Level	48 dB

Summary

Safety Precautions

General Safety Guidelines

Covers DANGER, WARNING, CAUTION symbols and basic rules for safe operation.

Electrical and Installation Safety

Specific safety warnings related to electrical hazards and proper installation procedures.

Operational and Handling Safety

Precautions to follow during the operation and handling of the air conditioner.

Maintenance and Environmental Safety

Safety measures for maintenance and environmental considerations during use.

Unit Components and Controls

Names of Parts Overview

Identifies and labels the key parts of the indoor and outdoor units.

Indoor Unit Display and Buttons

Explains the indicators on the indoor unit's display panel and the function of the RESET button.

Remote Controller Functions

Remote Controller Operation Buttons

Details the functions and operation of each button on the remote controller.

Remote Controller Display Indicators

Explains the meaning of various icons and indicators displayed on the remote controller.

Setup and Initial Use

Battery Installation and Clock Setting

Procedures for installing batteries and setting the current time on the remote controller.

Adjusting the Clock

Detailed steps for adjusting the clock on the remote controller after initial setup.

Using the Remote Controller

Controller Placement and Signal Reception

Guidance on optimal remote controller location and factors affecting signal reception.

Signal Reception Tones

Explanation of signal tones indicating successful transmission and basic setting defaults.

Automatic Operation Modes

Automatic Operation

Explanation of how the AUTO mode selects cooling, heating, or fan operation based on room temperature.

Automatic Operation (Auto Changeover)

Details on the AUTO (A) mode for automatic cooling or heating selection.

Standard Operation Modes

Cooling and Heating Operation

Instructions for using the COOL and HEAT modes for temperature control.

Dry Operation

How to use the DRY mode to reduce humidity in the room.

Specialized Operation Modes

8°C Operation Mode

Function for preventing freeze in uninhabited rooms by maintaining a minimum temperature.

Pure Operation and Hi Power Mode

Explanation of air purification (PURE) and rapid cooling/heating (Hi POWER) functions.

Timer and Memory Functions

Setting ON/OFF Timers

Instructions for setting the ON timer and OFF timer for automated operation.

Combined and Daily Timers

How to set combined ON/OFF timers and activate them on a daily basis.

Memory and My Comfort Settings

How to store and recall frequently used operation settings using MEMO and MY COMFORT.

Air Flow Direction Control

Adjusting Louver Direction

How to manually set the vertical and horizontal air flow louver positions.

Automatic Airflow Swing

Using the SWING button to automatically adjust the air flow direction.

Auto Restart and Temporary Operation

Auto Restart Operation Setup

Instructions for enabling and cancelling the auto restart function after power interruption.

Understanding Air Conditioner Operation

Mode Operation Explanations

Explanation of how Automatic, Hi Power, Sleep, and Dry modes function.

Operation Efficiency and Cleaning

Tips for Economical Operation

Advice on maintaining comfortable room temperature and optimizing energy usage.

Cleaning Operation and Temporary Use

Details on the automatic cleaning function and temporary operation feature.

Routine Maintenance

Indoor Unit and Remote Care

Cleaning procedures for the indoor unit and remote controller, plus long-term storage advice.

Air Filter Cleaning

Importance, frequency, and method for cleaning the air filters for optimal performance.

Air Filter Cleaning Procedure

Step-by-step instructions for safely removing, cleaning, and replacing the air filters.

Performance and Operating Conditions

Operational Features and Protection

Explanation of protection features, preheating, defrosting, and heating capacity.

Operating Condition Limits

Recommended temperature and humidity ranges for optimal cooling, heating, and dry operations.

Troubleshooting Common Issues

General Troubleshooting Checks

Checks for inoperative units and poor cooling or heating performance before requesting service.

Non-Defect Explanations

Common occurrences like condensation, noises, odors, and indicator behavior not indicative of defects.

Specific Indicator and Sound Issues

Troubleshooting for the PURE indicator turning on and various sounds from indoor/outdoor units.

Remote Controller Troubleshooting

Remote Control Malfunctions

Solutions for issues like incorrect mode switching, unresponsive fan speed, display problems, and signal loss.

Technical Specifications

Model Specifications Overview

Technical details, capacities, dimensions, and weights for various split type models.

Performance Conditions

Specified conditions (temperatures, humidity) under which air conditioning performance is determined.

Regulatory Information

EMC Directive Compliance

Information regarding EMC Directive 2004/108/EC, including manufacturer and importer details.

Related product manuals