Toshiba RAS-10GKHP-E - Page 48

− 47 −
FILE NO. SVM-06037
8-5-4. Wiring connection
1.
Remove the valve cover from the outdoor unit.
2. Connect the connecting cable to the terminal as
identified with their respective matched numbers on
the terminal block of indoor and outdoor unit.
3. When connecting the connecting cable to the
outdoor unit terminal, make a loop as shown in the
installation diagram of indoor and outdoor unit, to
prevent water coming in the outdoor unit.
4.
Insulate the unused cords (conductors) from any
water coming in the outdoor unit. Proceed them so
that they do not touch any electrical or metal parts.
<Stripping length of connecting cable>
For RAS-07GAH-E
Fig. 8-5-9
For RAS-07GA-E, RAS-07GAX
Fig. 8-5-10
CAUTION
Terminal block
Screw
Earth line
Connecting
cable
Terminal
screw
Cord clamp
Earth
line
70 mm
10 mm
10 mm
60 mm
60 mm
10 mm
10 mm
50 mm
Earth line
Connecting
cable
Screw
Cord clamp
Earth
line
Terminal
screw
Terminal block
CAUTION
• Wrong wiring connection may cause some
electrical parts burn out.
• Be sure to comply with local codes on running
the wire from indoor unit to outdoor unit (size of
wire and wiring method etc.)
• Every wire must be connected firmly.
NOTE
• Wire type: H07 RN-F or 245 IEC66 (2.0 mm
2
or
more)
For RAS-10GAH-E
Fig. 8-5-12
Fig. 8-5-11
100 mm
10 mm
10 mm
40 mm
Earth line
Connecting
cable
Screw
Cord clamp
Earth
line
Terminal
screw
Terminal block
1(L) 2(N)
Terminal block
Screw
Earth line
Connecting
cable
Terminal
screw
Cord clamp
70 mm
10 mm
10 mm
60 mm
Earth
line
For RAS-10GA-E, RAS-10GAX, RAS-10GAX-V
1(L) 2(N)