Toshiba RAS-16SAVP-E - AUTOMATIC OPERATION MODES; Automatic Operation; Automatic Changeover


88ENEN
When you set the air conditioner to AUTO mode, it automatically selects cooling, heating (heat pump models only), or When you set the air conditioner to AUTO mode, it automatically selects cooling, heating (heat pump models only), or fan onlyfan only
operation depending on the room temperature. (operation depending on the room temperature. (see see pagepage 17.)17.)
The fan speed and louver are also automatically controlled.The fan speed and louver are also automatically controlled.
StartStart
aa buttonbutton
Press this button to start the air conditioner.Press this button to start the air conditioner.
bb
AUTO button (AUTO)AUTO button (AUTO)
Press AUTO button.Press AUTO button.
cc
TTemempeperaratuture re bubutttton on (( ))
Set the desired temperature.Set the desired temperature.
 The OPERAThe OPERATION indicator (green) on TION indicator (green) on the display panel of the display panel of the indoor unit lights. Thethe indoor unit lights. The
operating mode is selected according to the room temperature and operation staroperating mode is selected according to the room temperature and operation startsts
after approximately 3 minutes.after approximately 3 minutes.
•• If the AIf the AUTO mode is uncomUTO mode is uncomfortable, you fortable, you can select the desired conditcan select the desired conditions manuallyions manually..
The fan speed and louver position can be changed, The fan speed and louver position can be changed, and MODE is also changed fromand MODE is also changed from
AUTAUTO to A when the O to A when the fan speed or louver position is changed.fan speed or louver position is changed.
The fan speed indicator is also shown.The fan speed indicator is also shown.
StopStop
buttonbutton
Press this button again to stop the air conditioner.Press this button again to stop the air conditioner.
When you set the air conditioner to A When you set the air conditioner to A mode or switch over from AUTmode or switch over from AUTO operation because of a change O operation because of a change in settings, the air conditionerin settings, the air conditioner
automatically selects cooling, heating (heat pump models only), or fan only operation automatically selects cooling, heating (heat pump models only), or fan only operation depending on the room temperature. (depending on the room temperature. (seesee
pagpagee 17.17.))
StartStart
aa
buttonbutton
Press this button to start the air conditioner.Press this button to start the air conditioner.
bb
Mode select button (MODE)Mode select button (MODE)
Select A.Select A.
cc TTemempeperaratuture re bubutttton on (( ))
Set the desired temperature.Set the desired temperature.
dd
Fan speed button Fan speed button (FAN)(FAN)
SSeelleecct t oonne e oof f ““AAUUTTOO” ” LLOOWW , , LLOOWW++ , , MMEEDD , , MMEEDD++ ,,
HHIIGGHH ..
•• The OPERAThe OPERATION indicator (green) on TION indicator (green) on the display panel of the display panel of the indoor unit lights. Thethe indoor unit lights. The
operating mode is selected according to the room temperature and operation staroperating mode is selected according to the room temperature and operation startsts
after approximately 3 minutes.after approximately 3 minutes.
•• The temperature, fThe temperature, fan speed and louver position an speed and louver position can be changed. Ycan be changed. You can select theou can select the
desired conditions desired conditions manuallymanually..
StopStop
buttonbutton
Press this button again to stop the air conditioner.Press this button again to stop the air conditioner.
AUT
AUTOMAOMATIC TIC OPERATIONOPERATION
AUTOMATIC OPERATION (AUTO CHANGEOVER)AUTOMATIC OPERATION (AUTO CHANGEOVER)
aa
cc
bb
TEMPTEMP
aa
bb
cc
dd
TEMPTEMP