Toshiba RAS-18N3KV Series - Installation Diagram of Indoor and Outdoor Units; Optional Installation Parts

EN
ES
FR
IT
DE
PT
PL
CZ
RU
CR
HU
TR
NL
GR
SV
FI
NO
DK
RO
BG
EE
LV
SK
SI
3
INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITSINSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS
Part
code
Parts name Q’ty
A
Refrigerant piping
Liquid side : dia. 6.35 mm
Gas side : dia. 12.70 mm
One
each
B
Pipe insulating material
(polyethylene foam, 8 mm thick)
1
C
Putty, PVC tapes
One
each
Optional Installation Parts
• Secure the outdoor unit with fi xing bolts and nuts if the unit is likely to be
exposed to a strong wind.
• Use dia. 8 mm or dia. 10 mm anchor bolts and nuts.
• If it is necessary to drain the defrost water, attach drain nipple 9 and cap
water proof ! to the bottom plate of the outdoor unit before installing it.
Fixing bolt arrangement of outdoor unit
Insulate the refrigerant pipes separately
with insulation, not together.
2
3
8
4
The auxiliary piping can be connected to
the left, rear left, rear right, right, bottom
right or bottom left.
Right
Rear
right
Bottom
right
Rear
left
Bottom left
Left
8 mm thick heat resisting
polyethylene foam
1
Batteries
Flat head
wood screw
Remote control
holder
Vinyl tape
Apply after carrying
out a drainage test.
Wireless remote
control
Saddle
Extension
drain hose
(Not available,
provided by installer)
Shield pipe
(Attach to the front panel.)
Air fi lter
Installation
plate
50 mm or more
170 mm or more
170 mm or more
100 mm or more
100 mm or more
600 mm or more
600 mm or more
6
5
Filter
Filter
Hook
Hook
(A)
(B)
(C)
(D)
108 mm
28 mm
125 mm
dia. 25 mm
Air inlet
Air outlet
Drain outlet
86 mm 102 mm
320 mm
600 mm
90 mm
600 mm or more
Remark :
• Detail of accessory and installation parts can see in the
accessory sheet.
• Some pictures might be different from the actual parts.
When installing the outdoor unit, leave open
in at least two of direction (A), (B), (C) and
(D) shown in the fi gure on the right.
The provided Remote Controller is a
wireless type, which also can be used as
a wire.
Please see “How to Connect The Remote
Controller for Wired Operation”, in case of
wired control is required.
8
Flat head
wood screw
&
(
Flat head
wood screw
Battery cover
Insert the cushion between the indoor
unit and wall, and tilt the indoor unit for
better operation.
For the rear left and left piping
Wall
Make sure to run the drain hose sloped
downward.
Do not allow the drain hose to get slack.
Cut the piping
hole sloped
slightly.
01_1115551208-EN.indd 301_1115551208-EN.indd 3 6/24/2557 BE 2:42 PM6/24/2557 BE 2:42 PM