Toshiba RAS-18UKHP-ES2 - 10-4. Outdoor Unit (RAS-18 UA-ES2)

FILE NO. SVM-03009
– 67 –
10-4 Outdoor Unit (RAS-18UA-ES2)
1) Stop the operation of the air conditioner and turn off
its main power supply or remove the power supply
cord.
2) Remove the electrical parts cover.
(2 screws ∅4 x 10L)
3) Remove 2 cord clamps (4 screws ∅4 x 22L) and
disconnect the power supply cord and connecting
cable after removing 6 screws on the terminal block
and 1 ground screw on the electrical parts base.
4) Remove the front cabinet. (8 scerws ∅4 x 10L)
(Pull the front lower portion toward you, and pull out
it upward to remove it.)
5) Remove the back cabinet. (4 screws ∅4 x 10L)
1) Perform the common procedure 1
2) Remove the capacitor band. (1 screw ∅4 x 10L)
3) Disconnect the lead wires from the capacitor
terminal.
1) Perform the common procedure 1
2) Remove the fixing screw. (1 screw ∅4 x 10L)
3) Disconnect the lead wires from the capacitor
terminal.
1) Perform the common procedure 1
2) Unlatch the relay and pull it upward.
3) Disconnect the lead wires from the relay terminal.
1) Perform the common procedure 1
2) Remove the fixing screw. (1 screw ∅4 x 10L)
3) Disconnect the lead wires from the terminal.
1) Perform the common procedure 1
2) Remove the terminal cover of compressor.
3) Remove the thermostat holder from the
compressor.
4) Disconnect the lead wires from the bimetal
thermostat.
1 Common
procedure
2 Running
capacitor
for compressor
3 Running
capacitor
for fan motor
4 Relay
5 Spark killer
6 Bimetal thermostat
No. Part name Procedures Remarks
Remove
8 screws ∅4 x 10L
Bimetal thermostat
Spark killer
Running
capacitor for
compressor
Running
capacitor for
fan motor
Relay
4 screws ∅4 x 22L 4 screws ∅4 x 10L