Toshiba RAS-24UAH-E - Setting and Adjusting the Clock; Clock Setting Procedures

6 EN
Setting the clock
Before you start operating the air conditioner, set the clock of the
remote control using the procedures given in this section. The clock
panel on the remote control will indicate the time regardless of
whether the air conditioner is in use or not.
Initial setting
When batteries are inserted in the remote control, the clock panel will
indicate AM 0:00 and will flash.
11
11
1 TIMER
button
Press the TIMER
button to set the current time.
Each press of the TIMER button changes the time in one minute
steps.
Pressing the TIMER button continually changes the time in ten
minute steps.
22
22
2 SET
SET
button
Press the SET
SET
button.
The current time is indicated and the clock starts.
Clock adjusting
11
11
1 CLOCK button
Press the CLOCK button.
The CLOCK display flashes.
22
22
2 TIMER
button
Press the TIMER button to set
the current time.
Each press of the TIMER button
changes the time by one minute.
Pressing the TIMER button
continually changes the time by
ten minutes.
33
33
3 SET
SET
button
Press the SET
SET
button.
The current time is indicated and
the clock starts.
Preparing the filters
11
11
1 Open the Air inlet grille with both
hands until the stop position.
22
22
2 Remove the Air filters from the
Front panel.
33
33
3 Install the Zeolite filter and
Purifying filter in the Filter frame
and then install it to the Air filters.
44
44
4 Insert the Air filters in the Front
panel and hook them into position.
55
55
5 Close the Air inlet grille.
PRESET
FAN MODE
Hi-POWER
ON OFF SET CLR
ECO
AUTO
TIMER
CLOCK CHECKRESET
FILTER
FIX
MEMO
START/STOP
1
2
3
SWING
FAN MODE
Hi-POWER
ON OFF SET CLR
ECO
AUTO
TIMER
CLOCK CHECKRESET
FILTER
FIX
SWING
MEMO
Push CLOCK
PRESET
FAN MODE
Hi-POWER
ON OFF SET CLR
ECO
AUTO
TIMER
CLOCK CHECKRESET
FILTER
FIX
SWING
MEMO
START/STOP
1
2
1
2
Zeolite filter Purifying filter
Filter frame
Air filter Air filter
Filter frame
Downloaded from AC-Manual.com Manuals