Toshiba RAS-H10C4KCVG-V - OPERATING THE AIR CONDITIONER; Initial Setup and Display; Basic Remote Operations; Energy Saving & Timer

1
Timer (White)
2
Operation (White)
●
Display brightness can be adjusted, follow procedure on !.
1
6
2
7
8
9
10
3
4
5
INDOOR UNIT DISPLAY
COOLING / FAN ONLY
OPERATION
PREPARATION BEFORE USE
DRY OPERATION
HI POWER OPERATION
ECO OPERATION
TIMER OPERATION
AIR FLOW DIRECTION
REMOTE CONTROL
AUTOMATIC OPERATION
Preparing Filters
1. Open the air inlet grille and remove the air lters.
2. Attach the lters. (see detail in the installation manual).
Loading Batteries (when use wireless operation.)
1. Remove the slide cover.
2. Insert 2 new batteries (AAA type) following
the (+) and (–) positions.
Remote Control Reset
1. Remove the batteries.
2. Press .
3. Insert the batteries.
Note:
●
Do not move the louver manually by others.
●
The louver may automation positioning by some operation mode.
1
Press : Move the louver in
the desired vertical direction.
2
Press : Swing the air
automatically and press again to stop.
3
For horizontal direction, adjust
manually.
1 Infrared signal emitter
2 Start/Stop button ( )
3 Mode select button ( )
4 Temperature button ( )
5 Fan speed button ( )
6 Swing louver button ( )
7 Set louver button ( )
8
O󰀨 timer button ( )
9
High power button ( )
0
ECO button ( )
!
Clear button ( )
@
Check button ( )
1
3 4
6
5
0
!
2
7
9
8
@
To automatically select cooling or fan only operation
1. Press : Select Auto A.
2. Press : Set the desired temperature. Min: 17°C, Max: 30°C
3. Press : Select AUTO, LOW , LOW+ , MED ,
MED+ , HIGH , or QUIET .
1. Press : Select Cool , or Fan only .
2. Press : Set the desired temperature. Min: 17°C, Max: 30°C
Fan Only : No temperature indication
3. Press : Select AUTO, LOW , LOW+ , MED ,
MED+ , HIGH , or QUIET .
For dehumidication, a moderate cooling performance is controlled automatically.
1. Press : Select Dry .
2. Press : Set the desired temperature. Min: 17°C, Max: 30°C
Note: DRY mode fan speed is set to Auto only.
To automatically control room temperature and airow for faster cooling operation
(Except in DRY and FAN ONLY mode)
Press : Start and stop the operation.
Note: Hi-POWER operation symbol will appear on remote control display.
Set the timer when the air conditioner is operating.
Note: TIMER OPERATION symbol will appear on remote control display.
Setting the OFF timer
1
Press for enter OFF timer setting.
2
Press for select desired OFF timer. (0.5 - 12 hrs)
3
Press for set OFF timer.
4
Press again for cancel OFF timer.
1 2
To automatically control room temperature to save energy (except in DRY and
FAN ONLY mode)
Press : Start and stop the operation.
Note: Cooling operation; the set temperature will increase automatically 1
degree/hour for 2 hours (maximum 2 degrees increase). For heating
operation the set temperature will decrease.
1144180203_EN,VT.indd 4 6/10/2564 18:30:49