E
Emily BellAug 11, 2025
Why Toshiba RAV-GM562ATP-E ON/OFF operation cannot be performed from remote controller?
- RrlongAug 11, 2025
The ON/OFF operation from the remote controller might be disabled when automatic address is being set up.
Why Toshiba RAV-GM562ATP-E ON/OFF operation cannot be performed from remote controller?
The ON/OFF operation from the remote controller might be disabled when automatic address is being set up.
Why is my Toshiba Air Conditioner compressor not operating?
The compressor might not be operating because of a 3-minute delay that occurs after the compressor is turned off.
Why Toshiba RAV-GM562ATP-E Air Conditioner outdoor fan does not rotate or air volume changes?
The outdoor fan might not rotate, or the air volume might change, when the high-temperature release operation control is active during heating operation.
Why is my Toshiba RAV-GM562ATP-E indoor fan not rotating?
The indoor fan might not be rotating when cool air discharge prevention control is working in heating operation.
Type | Split System |
---|---|
Cooling Capacity | 5.6 kW |
Heating Capacity | 6.3 kW |
Energy Efficiency Ratio (EER) | 3.21 |
Seasonal Energy Efficiency Ratio (SEER) | 6.1 |
Coefficient of Performance (COP) | 3.61 |
Power Supply | 220-240 V, 50 Hz |
Refrigerant | R32 |
Outdoor Unit Noise Level | 49 dB(A) |
Weight (Indoor Unit) | 13 kg |
Indoor Unit Dimensions (WxHxD) | 990 x 295 x 230 mm |
Outdoor Unit Dimensions (WxHxD) | 780 x 550 x 290 mm |
Safety precautions for handling R32 refrigerant during installation and servicing.
Guidelines for installing refrigerant piping with R32.
Procedure for recharging refrigerant.
Comprehensive safety guidelines for R32 refrigerant usage.
A summary of common troubleshooting steps and checks.
Detailed troubleshooting procedures for various issues.
Inspection procedures for major outdoor unit components.
Steps to troubleshoot using remote controller information.
Describes how to detect refrigerant leaks.
An outline of the compressor replacement procedure.
Procedure for removing and installing the compressor.