What does it mean if the outdoor unit inverter Idc is activated on my Toshiba RAV-SM1603DT-A?
If the outdoor unit inverter Idc is activated on your Toshiba Air Conditioner, it indicates that short-circuit protection for compressor drive circuit devices (G-Tr/IGBT) was activated.
What to do if my Toshiba RAV-SM1603DT-A drainage is out of order?
If the drainage of your Toshiba Air Conditioner is out of order, check the drain pipe for any clogging. Also, inspect the float switch circuit and the indoor P.C. board.
What to do if my Toshiba RAV-SM1603DT-A Air Conditioner is not receiving data from the remote controller or network adapter?
If your Toshiba Air Conditioner is not receiving data from the remote controller or network adapter, check the remote controller, the network adapter, and the indoor P.C. board.
What does it mean if my Toshiba RAV-SM1603DT-A detects an open phase?
If your Toshiba Air Conditioner indicates an open phase, the power cable might be connected incorrectly. Verify the open phase and voltages of the power supply.
What causes an indoor unit fan error in my Toshiba RAV-SM1603DT-A?
An indoor AC fan error on your Toshiba Air Conditioner indicates that the fan motor thermal relay has been activated, likely due to an issue with the indoor P.C. board.
What causes an outdoor unit fan error on my Toshiba RAV-SM1603DT-A?
An error in the outdoor unit fan of your Toshiba Air Conditioner (such as overcurrent or locking) indicates a problem in the outdoor unit fan drive circuit, potentially related to the Outdoor P.C. board.
What does it mean if my Toshiba RAV-SM1603DT-A displays an outdoor unit compressor breakdown?
If your Toshiba Air Conditioner reports an outdoor unit compressor breakdown, it means that the minimum frequency was reached in the current releasing control or short-circuit current (Idc) after direct excitation was detected.
What causes a heat sink overheat in my Toshiba Air Conditioner?
If your Toshiba Air Conditioner's heat sink is overheating, it signifies that the temperature sensor of the IGBT heat sink has detected an abnormal temperature.
What does it mean if my Toshiba RAV-SM1603DT-A Air Conditioner displays an outdoor unit high-pressure system error?
If your Toshiba Air Conditioner is showing a high-pressure system error, the IOL was activated, or an error was detected in the high-pressure releasing control using the TE.
What does it mean if my Toshiba RAV-SM1603DT-A Air Conditioner displays an outdoor unit discharge temp. error?
If your Toshiba Air Conditioner indicates an outdoor unit discharge temp. error, an error was detected in the discharge temp. releasing control.
General| Brand | Toshiba |
|---|---|
| Model | RAV-SM1603DT-A |
| Category | Air Conditioner |
| Language | English |
Crucial safety advice for installing the air conditioner to prevent hazards.
Important safety guidelines for operating the air conditioner to avoid risks.
Safety precautions when repairing or moving the air conditioner.
Additional installation precautions for safe and proper setup.
Further operational cautions for safe and efficient use.
Identifies and describes the components of the indoor unit.
Shows the separate sold part, the remote controller.
Identifies and describes the components of the outdoor unit.
Explains the various indicators and sections of the remote controller display.
Details the buttons and functions within the remote controller's operation section.
Steps for initial setup, power connection, and basic operating requirements.
How to select modes, air volume, and set temperature for operation.
Explains Auto Changeover, Heating, Defrosting, and 8°C Operation.
Step-by-step guide on setting and canceling timer operations.
Instructions for activating and deactivating the power saving mode.
Detailed steps to configure specific power saving settings.
Advice on temperature, ventilation, and curtains for energy saving.
Guidance on pre-operation checks and understanding protective device actions.
Instructions for cleaning air filters and the remote controller.
Steps for storing the unit and pre-operation checks.
Detailed list of parts requiring maintenance and recommended actions.
Explains protection features, power failure handling, and heating characteristics.
Details the recommended operating temperatures for cooling and heating.
Guidelines for choosing a suitable installation place and electrical connections.
Lists specific locations where the air conditioner should not be installed.
Steps to check before calling for service for common issues.
Describes noises or conditions that are not actual failures.
To Next Page
