Why Toshiba RAV-SM566KRT-E is not cooling?
If your Toshiba Air Conditioner isn't cooling, check if any doors or windows are open. Also, inspect the air filter for dust clogs. Ensure the air volume isn't set to 'LOW' or the operation mode to 'FAN', and verify that the set temperature is appropriate.
Why does my Toshiba RAV-SM566KRT-E show an outdoor unit discharge temp. sensor (TD) error?
If your Toshiba Air Conditioner displays an error related to the outdoor unit discharge temp. sensor (TD), it means that an open-circuit or short-circuit of the discharge temp. sensor was detected. Check the outdoor temp. sensor (TD) and the outdoor P.C. board.
What to do if Toshiba RAV-SM566KRT-E Air Conditioner detects gas leakage?
If your Toshiba Air Conditioner detects gas leakage, it indicates that there may be gas leakage from the pipe or connecting part. Check for gas leakage to resolve the issue.
What causes an indoor unit fan error in a Toshiba RAV-SM566KRT-E?
If your Toshiba Air Conditioner displays an error related to the indoor unit fan, it means an indoor AC fan error (fan motor thermal relay activated) was detected. Check the indoor fan motor and the indoor P.C. board.
Why is my Toshiba RAV-SM566KRT-E showing a LAN communication error?
If your Toshiba Air Conditioner has LAN communication errors, the issue might be a duplication of address in central control communication. To resolve this, check the address settings in central control communication.
What to do if Toshiba RAV-SM566KRT-E detects indoor unit water overflow?
If your Toshiba Air Conditioner detects water overflow, it could be due to drainage issues or a float switch activation. Check the drain pipe for any clogging, inspect the drainage system, and examine the float switch circuit and the indoor P.C. board.
What to do if open phase is detected in Toshiba RAV-SM566KRT-E Air Conditioner?
If your Toshiba Air Conditioner detects an open phase, it might be due to an incorrectly connected power wire. You should check the open phase and voltages of the power supply.
What to do if the switch does not work properly on Toshiba RAV-SM566KRT-E?
If the switch on your Toshiba Air Conditioner isn't working correctly, immediately stop running the unit, turn off the circuit breaker, and contact the dealer where you purchased the product.
What to do if my Toshiba RAV-SM566KRT-E does not run?
If your Toshiba Air Conditioner isn't running, check for a blackout, a blown circuit breaker, or activation of the protective device (look for blinking operation indicator on the wired remote controller). Also, ensure that the air intake or discharge of the outdoor unit isn't blocked.
General| Type | Air conditioner indoor unit |
|---|---|
| Multi-split | - |
| Product color | White |
| Built-in display | No |
| Hose length (max) | 30 m |
| Remotely operated | Yes |
| Air conditioner functions | Cooling, Heating |
| Cooling capacity in watts (max) | 5600 W |
| Cooling capacity in watts (min) | 1500 W |
| Heating capacity in watts (max) | 6300 W |
| Cooling capacity in watts (nominal) | 5000 W |
| Cooling energy efficiency (EER, W/W) | 3.01 |
| Heating energy efficiency (COP, W/W) | 2.75 |
| Operating temperature (cooling) (T-T) | -15 - 46 °C |
| Operating temperature (heating) (T-T) | -15 - 15 °C |
| Seasonal efficiency rating (cooling) (SEER) | 5.77 |
| Heating capacity in watts (nominal) (Average heating season) | 5300 W |
| Seasonal efficiency rating (heating) (SCOP) (Average heating season) | 4 |
| AC input voltage | 220-240 V |
| AC input frequency | 50 Hz |
| Energy efficiency class (cooling) | A+ |
| Power consumption (cooling) (max) | 1660 W |
| Power consumption (heating) (max) | 2440 W |
| Annual energy consumption (cooling) | 304 kWh |
| Hourly energy consumption (cooling) | - kWh |
| Annual energy consumption (heating) (Average heating season) | 1539 kWh |
| Indoor unit type | Wall-mountable |
| Indoor unit depth | 228 mm |
| Indoor unit width | 1050 mm |
| Indoor unit height | 320 mm |
| Indoor unit weight | 12000 g |
| Indoor units quantity | 1 |
| Cooling airflow (indoor unit) | 840 m³/h |
| Indoor unit noise level (high speed) | 57 dB |
| Outdoor units quantity | 0 |
Safety precautions for installation and servicing of R410A refrigerant.
Guidelines for installing refrigerant piping with R410A.
Required tools for working with R410A refrigerant systems.
Procedure for recharging refrigerant into the air conditioning system.
Materials and techniques for brazing refrigerant pipes.
Detailed control specifications for the high wall type unit.
Overview and initial checks for troubleshooting wired remote controller issues.
Troubleshooting procedures and error code explanations for high wall type units.
To Next Page
