25
XV545U (E/F) Web 177.8:228.6
Chapter 3: Using the remote control
Searching and sampling the code of a
device (8500)
If you do not know the device code for a particular
device, you can cycle the remote control through the
available codes for that device mode and sample the
functions to find the code that operates the target device.
The keys available to be sampled, provided they are
applicable to that mode, are p, 1, z, <, and S.
Invalid keys will be ignored while in program mode.
To cycle through each available device code and
sample its functions:
1 Press the appropriate mode select button on the
remote control.
2 While holding down E, press 8, 5, 0, 0. The remote
control will enter program mode.
3 Point the remote control at the target device and
press p (or other function buttons that are
available to be sampled).
4 If the device responds to the remote control:
Press E to store the device code. The mode select
button will blink two times, and the remote
control will exit the program mode.
If the device does not respond to the remote control:
Press B, and then press p. Repeat this step until
the device responds to the remote control, and
then press E.
Note: When a search cycle is completed, the mode select
button will blink three times. The remote control will begin
to cycle through the available codes again. If no key is
pressed within 10 seconds during programming, the
remote control will exit the program mode and return to the
previous code.
Using the volume lock feature (8000)
By default (factory setting), the remote control’s volume
keys (z Z and W) are locked to the “TV” device mode.
The remote control will operate the TV’s volume, even
when “TV” is not the current device mode.
If you unlock the remote control’s volume keys, each
device mode will have its own volume (if the device ID
has volume data). The remote control will operate the
volume of the device associated with the current device
mode.
If you lock the remote control’s volume keys to a specific
device mode, the remote control will operate the volume
of the device associated with the locked mode, even
when the locked mode is not the current device mode.
See “Using the remote control to operate your other
devices” on page 24.
To lock the remote control’s volume keys to a
specific mode (CABLE/SAT in this example):
1 Press CABLE/SAT.
2 While holding down the E button, press 8, 0, 0, 0.
3 Press z. The CABLE/SAT mode select button will
blink two times (locked).
The remote control’s volume keys will now operate
the volume of the device associated with the
CABLE/SAT mode, even when CABLE/SAT is not
the current device mode.
To unlock the remote control’s volume keys:
1 While holding down E, press 8, 0, 0, 0.
2 Press Z. The CABLE/SAT mode select button will
blink four times.
The CABLE/SAT mode will be unlocked.
Operational feature reset (8900)
This feature clears all programmed remote control
features not related to “Device code setup” and resets the
volume lock to the “TV” device mode.
To reset the remote control:
While holding down E, press 8, 9, 0, 0. The mode select
button will respond with four blinks.
52XV545U_EN.book Page 25 Monday, August 4, 2008 10:54 AM
To Next Page
Loading...
Need help?
General
