48
XV545U (E/F) Web 177.8:228.6
Chapter 6: Using the TV’s features
Scrolling the TheaterWide
®
picture
(TheaterWide 2 and 3 only)
You can set separate scroll settings for the TheaterWide
2 and TheaterWide 3 modes for each input.
To set the scroll settings:
1 Press Y and open the Video menu.
2 Highlight Theater Settings and press T.
3 In the Picture Size field, select either TheaterWide
2 or TheaterWide 3 (you cannot scroll in any other
mode).
4 Press b to highlight the Picture Scroll field.
5 Press C or c to scroll the picture up and down as
needed, from –10 to +20.
6 To save the new settings, highlight Done and press
T.
To revert to the factory defaults, highlight Reset and
press T.
Using the auto aspect ratio feature
When the auto aspect ratio feature is set to On, the TV
will automatically select the picture size when one of the
following input sources is received:
• A 480i, 480p, 720p, 1080i digital signal from the ANT/
CABLE input
• A 480i signal from the Video 1 or Video 2 input
• A 480i signal from the ColorStream HD1 or HD2 input
• A 480i, 480p, 720p, 1080i, 1080p, or VGA (60/72/
75Hz) signal from the HDMI 1/2/3/4 input
Note: The auto aspect ratio feature is not applicable to the PC
input.
To turn on the auto aspect ratio feature:
1 From the Video menu, highlight Theater Settings
and press T.
2 In the Auto Aspect Ratio field, select On.
3 To save the new settings, highlight Done and press
T.
To revert to the factory defaults, highlight Reset and
press T.
To turn off the auto aspect ratio feature:
Select Off in step 2 above.
Mode
Picture Settings
Noise Reduction
Video
Game Mode
ColorMaster
Theater Settings
Off
x.v.Color Selection
Auto
Auto Brightness Sensor
On
TheaterLock
Off
Sports
52XV545U_EN.book Page 48 Monday, August 4, 2008 10:54 AM
To Next Page
Loading...
Need help?
General
