Document 60763-000
Terminal Emulator Example
To configure the RemotEye II from a Windows platform, use Hyperterminal. Hyperterminal is a
standard terminal emulator packaged with any Windows operating system. Launch the
Hyperterminal program by navigating to Start →Programs →Accessories →Hyperterminal
→Hyperterminal, and follow the prompts.
Enter a name and select an icon for the application at the Connection Dialog box.
Select a direct connection to an appropriate com port listed in the pull-down menu.
Ensure that the Properties dialog box is setup as follows:
Baud Rate — 9600
Data Bits — 8
Parity — None
Stop Bits — 1
Flow Control —- None
Press [Enter] and the RemotEye II version and Password field will be displayed (see Error!
Reference source not found.).
Enter the password (default is “public”) and press [Enter] to display the RemotEye II Main Menu.
+====================================================================+
| [ TIC RemotEye II Login Menu ] |
+====================================================================+
Enter Password: ******
The seven options provided in the RemotEye II Main Menu provide access to all system
RemotEye II configuration parameters. These options (see the Main Menu Description on
Figure
4: Console Main Menu) and their submenus are discussed in more detail in the next section.
+====================================================================+
| [ TIC RemotEye II Main Menu ] |
+====================================================================+
1. TIC RemotEye Configuration
2. SNMP Communities
3. SNMPV3 USM Table
4. Trap Receiver Table
5. Reset Configuration To Default
6. Save and Exit
7. Save and Restart Agent
Please Enter Your Choice =>
Figure 4: Console Main Menu
Figure 3: Console Login Screen
To Next Page
Loading...
