79
Remote Control & DMS Front Lights
6
2. Enter the search code. Refer to the table below and use the number keys on your
remote control to enter the appropriate code.
After you press the fourth digit of the code, the red light on the end of the remote
control will flash twice, then remain on.
3. Test the remote control. Point the remote control at the TV or A/V receiver. Press
CHAN UP to test the first code. The test is successful if the TV or A/V receiver
responds (by powering off, changing input, or muting, depending on the function you
are trying to program). If there is no response, wait two or three seconds, then press
CHAN UP again. Continue doing this until the TV or A/V receiver responds.
When the TV or A/V receiver does respond, press ENTER to select the current code.
The red light at the end of the remote control will flash three times to indicate that the
remote control is properly coded to control your device.
When the red light on the end of the remote control turns off, you have reached the end
of the available codes.
Unfortunately, due to the great variety of TVs and A/V receivers, some makes and
models are not compatible with your Digital Media Server’s remote control. If you
reach the end of the available codes without finding a code that works with your
device, you will need to use your TV or A/V receiver’s remote to turn it on and off,
and control the volume.
To Test:
TV power, volume,
and mute
TV input A/V receiver power,
volume, and mute
A/V receiver volume
and mute only
Enter:
0999 0999 1999 1999
To Next Page
Loading...
