18
Chapter 1
Connecting Your DMS
Watching One Channel & Recording Another
Antenna or Cable with No Cable Box
Connect the Coaxial RF cable coming from the wall to the RF In jack on the DMS.
Connect a Coaxial RF cable from the RF Out jack on the DMS to the Antenna/RF In
jack on your TV.
Connect a Composite A/V cable from the Audio/Video Output jacks on the DMS to
the Audio/Video Input jacks on your TV.
Connect the phone cord (see page 8).
Plug in all power cords and turn on your TV. You may have to find the correct TV
input setting by pressing the Input or TV/Video button on your TV’s remote control
until you see the Welcome screen. (For more help, see page 131.)
Once you see the Welcome screen, you’re ready to complete Guided Setup. If you need
help, see Chapter 2.
For this setup,
use cable bag .
The audio/video cables shown here are for
example only. For help choosing cables,
see page 4.
®
Antenna
In
INPUT
VIDEORL
®
Digital Media
Server
Television
35
2
4
1
How do I watch one channel
and record another?
To watch live TV on one channel while the
DMS records another, put the DMS into
Standby mode. To do this, press the ON/
STANDBY button on the Digital Media
Server’s front panel. Then use your TV’s
remote to change channels. Because this
signal simply passes through the DMS, it
has no TiVo service functionality (so you
can’t pause or rewind live TV).
To watch video from your DMS again: First,
press the TiVo button so that the DMS
displays TiVo Central
®
. (This will not
interrupt any recording in progress.) Then
press the Input, or TV/Video button on your
TV’s remote until you see TiVo Central.
®
To Next Page
Loading...
