90
Chapter 6
Messages & Setup
Standby
You can put your Digital Media Server in Standby mode by selecting Standby in
Messages & Setup, or by pressing the ON/STANDBY button on the front panel. To take
your DMS out of Standby, press the TiVo button or the LIVE TV button on the remote, or
the ON/STANDBY button on the front panel.
In Standby mode:
• Your TV shows a black screen and the lights on the front of the DMS go out.
• Programs that are being recorded or are scheduled to record will still be recorded. (If a
program is being recorded, the red light will turn on.)
• Any antenna or cable signal connected to the Digital Media Server’s RF In jack will
continue to be passed through to the RF Out jack. There is no TiVo service
functionality on any signal coming from the RF Out jack.
• The DMS will still connect to the TiVo
®
service. (If the DMS is connecting, the
yellow light will turn on.)
• If you temporarily turned off Parental Controls, Standby mode re-enables them. (See
page 71 for more on Parental Controls.)
• The DMS will continue to save a portion of live TV—up to 30 minutes of
programming.
• If live TV was paused when Standby was selected, the DMS will remain paused for up
to 30 minutes.
To Next Page
Loading...
