Part I: Getting to Know Your Computer
Getting Started
Setting up your computer
39
Removing a memory module
1 Follow steps 1 through 5 in Installing additional memory
(optional) on page 36.
2 Gently pull up on the module to disconnect it, then
gently pull it out of the slot.
3 Complete the procedure by following steps 9 through
11.
Connecting a mouse
You may want to use a mouse instead of the computer’s
built-in pointing device. A USB mouse disables the
AccuPoint II pointing device. With a PS/2 mouse, you can
choose to have the
AccuPoint II pointing device active at the same time.
Connecting a USB mouse
To connect a USB mouse, plug the mouse cable into one of
the USB ports.
Connecting a PS/2 mouse
CAUTION: The computer must be turned off. Connecting a
PS/2 mouse with the computer’s power on may damage the
mouse, the computer, or both.
To connect a PS/2 mouse, plug the mouse cable into the
PS/2 port.
By default, the system configures the PS/2 mouse to work
when it is connected at power on, or the AccuPoint II
pointing device to work otherwise.
To Next Page
Loading...
