7-7
HW S
ETUP
AND
P
ASSWORDS
To change the boot drive, follow the steps below.
1. Hold down F12 and boot the computer.
2. The following menu will be displayed with the following icons: Built-in HDD,
CD-ROM, FDD, Network (LAN), PC (ATA) card boot.
NOTE: A bar will appear only under the selected device.
3. Use the left/right cursor keys to highlight the boot device you want and press
Enter.
NOTES: 1. If a supervisor password is set, the menu above does not
appear when you use the user password to start the
computer.
2. The selection method above does not change the boot
priority settings in HW Setup.
3. If you press a key other than one of those above or if the
selected device is not installed, the system will boot according
to the current setting in HW Setup.
4. Support of PC (ATA) card boot is guaranteed only for
TOSHIBA PC card HDDs.
5. A PC (ATA) card takes the position of HDD in the Boot
Priority Options list.
HW Setup
To Next Page
Loading...
