User's Manual
7-8
HW SETUP AND
PASSWORDS
HDD Priority Options
If more than one HDD is installed in the computer, this option lets you set the
priority for HDD detection. If the first detected HDD has a boot command, the
system will boot from the HDD.
Built-in HDD
−> −>
−> −>
−> PC Card (Default)
HDDs are searched for a boot command in the following
order: the built-in HDD, and the PC card. (Default)
PC Card
−> −>
−> −>
−> Built-in HDD
HDDs are searched for a boot command in the following
order: the built-in HDD and the PC card.
NOTE: If a boot command is not found on the first detected HDD, the
system will not boot from the other HDD. It will search the next device in
the boot priority for a boot command.
Network Boot Protocol
This feature sets the protocol to remotely boot from the network.
[PXE] Sets PXE as the protocol. (Default)
[RPL] Sets RPL as the protocol.
NOTE: The Wake-up on LAN function consumes power even when the
system is off. Leave the universal AC adaptor connected while using this
feature.
Keyboard
Wake-up on Keyboard
When this feature is enabled and the computer is in Standby mode, you can turn on
the computer by pressing any key. It is effective only for the internal keyboard and
only when the computer is in standby mode.
Enabled Enables the Wake-up on Keyboard.
Disabled Disables the Wake-up on Keyboard. (Default)
To Next Page
Loading...
