4 Replacement Procedures 4.4 Memory Module and RTC battery
4-14 Satellit /Satellite Pro /C850D/C855D /L850D/L855D Maintenance Manual
4.4 Memory Module and RTC battery
Removing the Memory Module and RTC battery
Remove the memory module and RTC battery according to the following procedures and
Figures 4-5, after checking that the computer is turned off in boot mode.
CAUTION: Remove the optional memory after turning off the computer. If this is
violated, the computer or memory can be damaged.
1. Turn the computer upside down.
CAUTION: Do not touch the connectors on the memory modules or in the computer.
Contaminated connectors can cause memory access problems.
Memory module
RTC battery
Memory slot
Figure 4-5 Removing the memory module and RTC battery
2. Spread out the two memory lock latches so that the memory module pops up.
3. Pull the memory module up and out at an angle, using care to avoid touching the
connectors.
4. Remove the memory module.
5. Raise the RTC battery with a plastics stick from the battery locker hole.
6. Remove RTC battery.
To Next Page
Loading...
