4.26 FL Inverter Board 4 Replacement Procedures
4.26 FL Inverter Board
Removing the FL Inverter Board
To remove the FL inverter board, first remove the battery pack, the display assembly, display
mask, and LCD module, then follow the steps below:
1. Remove the black M2x4 screw securing the FL invert board to the top chassis.
Figure 4-78 Removing the FL inverter board screws
2. Disconnect the two connectors on either side of the FL invert board.
Figure 4-79 Removing the connectors
Satellite P200
/ P205
Series Maintenance Manual
[CONFIDENTIAL]
4-65
To Next Page
Loading...
