Replacement Procedures
4.15 CPU
Removing the CPU heat sink
The following describes the procedure for removing the CPU heat sink (See Figure 4-15-1 to
4-15-2).
1. Disconnect the Heat sink cable from the connector on the system board
2. Remove the following screws securing the heat sink holder along 1 to 4.
• M2×2 SPRING screw x4
NOTE: When removing the heat sink holder, be sure to remove the screws in the reverse
order of the number marked on the holder.
3. Remove the CPU heat sink.
Figure 4-15-1 Remove the CPU heat sink
Satellite P500 and Satellite Pro500 Maintenance Manual (960-Q08)
4
To Next Page
Loading...
