Replacement Procedures
NOTE: Apply the silicon grease enough to cover the chip surface using the special
applicator.
Figure 4-29 Applying silicon grease
6. Install the CPU heat sink and heat sink holder and secure them with the following
screws along 1 to 6.
M2.0×3.0 BIND screw x6
7. Connect the Heat sink cable to the connector on the system board
NOTE: When securing the heat sink holder, be sure to secure the screws in the order of
the number marked on the holder.
Satellite U300 and Satellite Pro U300 Maintenance Manual (960-Q08) 49
To Next Page
Loading...
