Replacement Procedures
4.9 Top assembly
Removing the Top assembly
The following describes the procedure of removing the cover assembly.
1. Turn over the computer.
2. Remove the following screws securing the cover assembly from the back and bottom
of computer.
• M2.0×5.0 FLAT BIND screw Back x9
• M2.5×8 FLAT BIND screw Back x4
Figure 4-14 remove the screws (back)
3. Disconnect the touch pad flat cable/Fingerprint cable/Bluetooth Cable from the
connector on the system board.
Satellite U400/Satellite Pro U400/PORTEGE M800
Maintenance Manual 28
To Next Page
Loading...
