Toshiba SD-2300 - Page 81

Pickup (P.U.) transmission initial
operation does not occur.
The pickup transmission initial operation is carried out to
determine the initial position by transmitting the pickup to the
innermost position once (start-limit switch (pin 4 of CN502)
develops "L".) and to the external direction at low speed
(start-limit switch develops "H", turning off the switch.).
1
Does pulse of
1.65V 1.65V develop at
pin 162 of IC402?
Check BUS between IC402
and IC603 and oscillation.
Check feed gear.
N
Y
2-1
"No disc" misjudgement display of
disc presence.
Does lens move with
UP/DOWN full stroke in
focus direction?
Is laser current normal?
Check IC402.
Does search signal
output at both edges of focus coil?
(Pins 10 to 13 of CN501)
Does focus search
voltage of 1.65V 0.4V develop
at pin 1 of IC503 (E554)?
Check pickup head
and wiring.
Does RFSB signal
develop more than 0.3V?
Check IC502.
Lens cleaning.
Replace pickup head.
Check peripheral
circuit of IC603.
Check IC502.
Y
Y
Y
Y
3
N
N
N
Y
N
N
Fig. 1-3-2
Fig. 1-3-3