1-1-3. Tray Panel
<Tray Ejection>
1. Slide the slider (2) of the mechanism chassis assembly
(1) with a screwdriver, etc. in the arrow direction, so
that the tray (3) is ejected.
Note:
• Take care not to damage the pickup and other parts.
Fig. 2-1-4
<Tray Panel Removal>
1. Eject the tray (3).
2. Twist the tray panel (4) a little in the arrow A direction
with the tray (3) hold by hand to release two claws and
lift up the tray panel (4) in the arrow B direction, then
the tray panel (4) is removed.
(Refer to Fig. 2-1-5.)
3. When mounting the tray panel (4), insert the tray panel
(4) along the grooves of the both sides of the tray (3)
until clicking.
OK
Tray
NG
Spring
Mechanism
chassis assembly
NG
This part should be touch
to the left side of the tray.
OK
NG
Press down by finger
unitil fix the clamper assembly
No floating
Floating NG
<Mounting >
1. The spring for tray side pressure is inserted into the
portion “A”. (Refer to Fig. 2-1-2.)
2. By referring to Fig. 2-1-3, insert the spring normally
and mount the clamper stay.
Fig. 2-1-3
Screw
driver
Mechanism
chassis assembly (1)
Tray (3)
Front panel
Slider (2)
To Next Page
Loading...
