Toshiba SD700KY - Connections; Connecting to Television

6
English
Connecting to television
IMPORTANT!
– You only need to make one video connection
from the following options, depending on the
capabilities of your television.
– Connect the DVD player directly to the
television.
Using Composite Video Jack(CVBS)
A Usethecompositevideocable(yellow)toconnect
the DVD player'sVIDEO(CVBS)jacktothevideo
input jack(or labelled as A/V in,Video In or
 Composite)ontheTV(cablesupplied).
To hear the sound of this DVD player through your
TV,usetheaudiocables(white/red)toconnect
 AUDIOOUT(L/R)jacksoftheDVDplayerto
corresponding AUDIO IN jacks on the TV(cable
 supplied).
Using Component Video Jacks(Y, PB, PR)
IMPORTANT!
-The progressive scan video quality is only
possible when using Y, PB, PR and a progressive
scan TV is required.
A Usethecomponentvideocables(green/blue/red)to
connect the DVD player' s Y, PB, PR jacks to the
corresponding Component video input jacks (or
labelled as Y, Pb, Pr)ontheTV(cablenotsupplied).
B Usetheaudiocables(white/red)toconnectAUDIO
OUT(L/R)jacksoftheDVDplayertothe
corresponding AUDIO IN jacks on the TV(cable not
supplied).
C Proceed to page 11 for detailed Progressive Scan set
up.
Using a RF modulator
IMPORTANT!
-If your TV only has a single Antenna In jack (or
labelled as 75 ohm or RF In), you will need an RF
modulator in order to view the DVD playback on
the TV.
A Usethecompositevideocable(yellow)toconnect
the DVD player'sVIDEO(CVBS)jacktothevideo
inputjackontheRFmodulator(cablesupplied).
To hear the sound of this DVD player through your
TV,usetheaudiocables(white/red)toconnect
 AUDIOOUT(L/R)jacksoftheDVDplayertothe
corresponding AUDIO IN jacks on the RF modulator
(cablesupplied).
B UsetheRFcoaxialcable(notsupplied)toconnect
ANTENNA OUT or TO TV jack on the RF modulator
to the ANTENNA IN jack on the television.
C Connect the Antenna or Cable TV service signal to
the ANTENNA IN or RF IN jack on the RF modulator.
(It may have been connected to your TV previously.
DisconnectitfromtheTV.)
Connections
Helpful hint: Before making or changing any connections, make sure that all the devices are
disconnected from the power outlet.