Toshiba Strata DKT3010F-S - Page 45

32
Strata CTX DKT3000/2000-Series Digital Telephone October 2002
Call Forward Advanced Operation
Station Call Forward Procedures
The following table contains Call Forward Button sequences. You can do a Call Forward function by,
one, entering the button sequence as described, or two, by programming a Flexible Button to perform
the sequence. See “Programming Feature Buttons” on page 67 for instructions on programming a
Flexible Button.
Some Call Forward features require a Pass Code entry. Use the following procedure to change your
Pass Code.
➤
To change your Pass Code
➤ Press Extension button +
#670
+ ext. no. + old Pass Code (1~15 digits) +
#
+ new Pass Code
(1~15 digits) +
#
.
➤
To use the Call Forward button sequence
➤ Follow the instructions in the following table, shown under “Button Sequence.” Some features
require additional input, such as:
♦
Destination – If the destination is an outside number, press
#
after entering the destination.
The CTX accepts destination numbers of up to 32 digits.
♦
Timer – This is a two digit entry representing how long (eight to 60 seconds) your telephone
should ring before forwarding the call. If you enter one digit, you must press
#
after entering
the single digit.
♦
Pass Code – A four-digit code established by system programming to prevent unauthorised
changes. The code applies to the station to be forwarded; not to the station entering the code.
Note
In the following table, (Tone) means that a confirmation tone will play at that point in the
sequence.