Toshiba T3100e - Page 89

File No.
960-010
(5) After formatting the hard disk, the Format complete
message will then appear.
(6) Press the Enter to return to the HARD DISK FORMAT menu.
3. Good track FORMAT or Bad track FORMAT Selection
(1) When Good track FORMAT or Bad track FORMAT is selected,
the following message will appear.
Drive number select (1:#1, 2:#2) ?
(2) Select a drive number. Type the drive number and press
Enter. The following message will appear.
Interleave number (3/1-3) ?
(3) Select an interleave number. (Usually select 3.) Type
the number and press Enter. The following message will
appear.
[HOD TYPE]
[HOD TYPE]
[HOD TYPE]
CYLINDER
HEAD
SECTOR
=
=
=
XXX
X
XX
Press [track number (CCCH)] key?
(4) Type a track number (four digits) and press Enter.
(The first three digits are the cylinder number and the
last digit is the head number.) This executes the
formatting of good tracks or bad tracks.
NOTE: This program can format only one track per
operation. If it is desired to format several good
tracks or bad tracks, repeat the operation as many
times as necessary.
(5) After formatting the track of the hard disk, the Format
complete message will appear.
(6) Press the Enter to return to the HARD DISK FORMAT menu.
3-33