3. Display
Plasma display adaptor -VGA compatible adaptor
Display device -Plasma
Plasma display mode -Color
Plasma gray scale - Normal:Semi-bright
Intense:Bright
4. Printer port type -Output port
5. Serial port
IRQ SIO base address -3E8h
Serial A IRQ level -4 (I/O base address=3F8h)
Serial B IRQ level -3 (I/O base address-2F8h)
Toshiba modem IRQ level -Not used
6. Bus speed -High
_??? moves between items, <----> selects values
1 exits, F5 sets default, F10 record changes
The menu above shows an example of setup options as they may be
currently stored in memory. Since the options shown reflect the
previously set options, the display you can see may be different
from the one above. The options shown under item 3, "Display",
differ depending on the option selected for "Plasma display
adaptor".
Notice that selecting the type of diskette drive is not an option.
The T5200 automatically determines what type of internal diskette
drive is installed. Also, you don't have to run the SETUP of
DIAGNOSTICS MENU to use an external 5 1/4" diskette drive.
Press F1 if the setup options displayed accurately reflect
your hardware configuration and no changes are necessary. The
system restarts.
Changing Setup Values
You can change the setup automatically or manually.
<fig id=MMS\5200\52003_45.TIF>Page 3-45</fig>
Automatic Reset
Follow the steps to set the values automatically:
1. Press F5. This instructs the program to reset all the
options to their factory preset values.
The program calculates how much conventional, extended and expanded
memory your T5200 has, based on whether or not you have memory
expansion kits installed.
Setup stores the value it calculates in configuration memory along
with the factory preset values for the other options. The [[ System
setup ]] menu displays the new values.
2. Confirm that the new values are correct. To change any option(s),
go to the next section, Manual Reset.
3. If the new values are correct, press F1. The system
restarts.
Manual Reset
To Next Page
Loading...
