English - 16 -
Link options
Press OK to open the Link Options menu screen. Current Start url and Settings url
links will be displayed. These items are for information only and not selectable and can
only be changed by USB operation command and RS232. See USB operation and
RS232 command list Open browser initial page and NTP server
NTP server to one that is more suitable for the location where the display is to be used.
Note:
Start URL and Settings URL availability is depending on model.
Pixel shift
Enables or disables pixel shifting. This option can be used to avoid image retention (after
USB Information
Press OK to open the USB information menu screen. Current Total space and Free
space informations of the connected USB device will be displayed. You can also format
the connected USB device using the Format Disk
option in this menu. (FAT32 format
only)
Power on Delay
Sets a delay value at power on. This value can be set from 0 to 2000 ms in steps of 100
ms. The Display will turn on after the set delay time is expired.
USB operations
Highlight and press OK
to perform USB operations. See separate USB operations
command list for available functions available on your monitor.
No Signal
set input source. Failover and Input Search options are available. Sets the behavior
Failover and Input Search options are available.
Signal OSD will be displayed on the screen. The setting of the Auto Play option in the
If Input Search is selected the Display will search all available input sources consecutively
be displayed and the Display will turn itself off after a period of 30 seconds.
Note: To set no signal image see USB operation command list.
No Signal
Power off
received from the selected source.
This feature will only work if all of the following circumstances occur:
-No Signal option is set as Failover.
USB device is not connected to the Display / USB device is connected but there are no
Auto launch
CMS(Start url), Open Browser(Open Browser
initial page) and Disabled options are available.
Set as ‘On’ to enable the Display to reopen with the closing status.
Panel Lock
Set as ‘Off’ to prohibit the use of the buttons on the Display.
RCU Inhibit
Set as ‘On’ to inhibit the use of the remote. Remote control will function in Stand-By
mode independently from the setting of this option. If this option is set as ‘Limited’
will be functional.
Volume
Press OK to see available Volume Settings menu options.
USB Option
Set as ‘Off’ to disable the USB ports on the Display. You can also set this option as 5V
to provide 5 volts power over USB. In this case it will still not be available to browse the
USB content via Media Browser feature of the Display.
Bootup Picture
Off the last set picture
mode will be used at power on.
To Next Page
