General Safety Instructions
Please read the following safety and operating instructions before using your Product.
Keep the information near your Product for future reference. Also, please be sure to
read your electronic User’s Guide as it contains additional important Safety Information.
Indicates a potentially hazardous situation which, if not avoided, could
result in serious injury.
AC Adaptor
Always use the Toshiba AC adaptor that was provided with your device or as specied
by Toshiba and use correct power source specied on the regulatory label of device or
adaptor. Always ensure a secure electrical connection. Be careful if you use a multiple
connector to avoid current overload on one socket.
Battery Pack
Do not expose the battery pack to heat or shock.
Disassembly, Modification or Tampering
Do not disassemble, modify, tamper with or repair your device (including AC adaptor or
power cable/cord).
Choking Hazards
Keep device away from small children. This device is not a toy and may be hazardous
to small children, for example, small detachable parts may be a choking hazard.
Cleaning
Unplug device from the electrical outlet before cleaning. Do not use liquid cleaners or
aerosol cleaners. The injected combustible gas produced by these types of cleaners
may remain inside of your product. The electrostatic spark from the motor or contact
point of switch may ignite the gas residue, which could result in an explosion, re, or
burn injury. Instead use a lightly dampened cloth for cleaning in general and remove
dust with a dry cloth.
Hot Surfaces
Allow the equipment’s internal components and hot-pluggable drives to cool before
touching them
Power Cables/Cords and Power Source
Always use power cables/cords and power sources that comply with the voltage and
frequency specications and requirements of the country of use.
Service Provider
Disconnect device from the electrical outlet and take device to an authorized Toshiba
service provider if:
• AC adaptor or power cable/cord is damaged.
• Liquid has spilled into device or an object (such as a screw, staple or paper clip) has
entered device.
• Device has been dropped, subject to shock or impact and/or damaged in some way.
• Noticeable signs of overheating, smoke, deformation, cracks, leaks or unusual odor
occur.
• Service is needed on component inside compartments requiring opening or removal
of covers.
Unstable Surfaces
Do not use Product on an unstable table, cart or stand.
To Next Page
Loading...
Need help?
General
