User’s Manual 3-13
Replacing the memory module
3. Align the two tabs on the lower edge of the keyboard with the slits on
the computer and seat the keyboard in its original position. Refer to
Removing the keyboard (2). Replace the three screws removed in step
6 above.
4. Seat the keyboard brace in its original position.
5. Replace the battery pack as described in the User’s Guide for your
computer.
TECRA M2
■ Main memory module
1. Firmly push the new memory module into the socket and push it down
so it lies flat and is secured by two latches on either side.
Installing the memory module
2. Seat the metal bracket over the keyboard cable and secure it with one
screw.
3. Insert tabs on the front of the keyboard into corresponding notches on
the computer and seat the keyboard in its original position.
4. Replace the two screws to secure the keyboard.
5. Seat the keyboard brace and press to secure latches.
6. Replace the screw removed from the battery compartment.
7. Install the battery pack. Refer to replacing the battery pack section in
the User’s Guide for your computer.
Be sure to replace all screws that were removed in step 6. Do not leave
foreign objects, such as tape or dropped screws, in the computer.
Slot A
When seating the keyboard, be sure to fit the flexible cable under the
palmrest if it was pulled out while you were removing the keyboard.
Be sure to replace both screws removed in Removing the keyboard brace
and two screws. Make sure not to drop any screws into the computer.
To Next Page
Loading...
