2 Troubleshooting Procedures 2.14 Sound Troubleshooting
2-54 [CONFIDENTIAL] TECRA A9(S5/P5/S200) Maintenance Manual (960-633)
2.14 Sound Troubleshooting
This section describes how to determine if the computer’s sound functions are functioning
properly. Perform the steps below starting with Procedure 1 and continuing with the other
procedures as required.
Procedure 1: Diagnostic Test Program Execution Check
Procedure 2: Connecor Check
Procedure 3: Replacement Check
Procedure 1 Diagnostic Test Program Execution Check
Insert the Sound test program in the USB floppy disk drive, turn on the computer and run the
test. Refer to Chapter 3, Tests and Diagnostics, for details.
If an error is detected, go to Procedure 2.
To Next Page
Loading...
